[Stackless] Problems building Stackless 3.0
Simon Frost
sdfrost at ucsd.edu
Mon Jul 14 20:09:38 CEST 2003
Dear Stackless list,
I've had problems building Stackless 3.0. Normally, I just use:
./configure
I then edit the Makefile so that the version reads '2.2s'
and then
make altinstall
Although this builds libpython2.2s just fine, when it builds all of the
modules, it tries to link with libpython2.2. I haven't run into this
problem with SP2.0. Any ideas?
Best
Simon
Simon D.W. Frost, M.A., D.Phil.
Department of Pathology
University of California, San Diego
Antiviral Research Center
150 W. Washington St., Suite 100
San Diego, CA 92103
USA
Tel: +1 619 543 8080 x275
Fax: +1 619 298 0177
Email: sdfrost at ucsd.edu
The information transmitted in this e-mail is intended only for the
person(s) or entity to which it is addressed and may contain
CONFIDENTIAL and/or privileged material. Any review, re-transmission,
dissemination or other use of or taking of any action in reliance upon
this information by persons or entities other than the intended
recipient is prohibited. If you received this e-mail in error, please
contact the sender and delete/destroy the material/information from any
computer.
_______________________________________________
Stackless mailing list
Stackless at www.tismer.com
http://www.tismer.com/mailman/listinfo/stackless
More information about the Stackless
mailing list